MIL-PRF-22191F
TABLE III. Examination of end item for defects in appearance, construction,
and workmanship Continued.
EXAMINATION
DEFECT
Workmanship
Blister, crack, cut, hole, tear, sharp crease or wrinkle, chafed
spot, or scuff mark. (Note: Defects do not apply to outer
convolution of roll.)
Evidence of delamination or embrittlement.
Edges not clean cut; ragged, crushed, or uneven.
Construction
Not uniform; layer or section missing, selvage present.
Identification markings
Illegible, incorrect, incomplete, or omitted.
Do not appear on backing surface of material if applicable;
not continuous lengthwise.
Color is not blue.
Complete marking not repeated as specified in 3.6.
Tags or sheets, when applicable, not properly located
4.3.2.2 Examination of the end item for defects in general construction. The sample unit
for this examination shall be one roll or one package of sheets, as applicable.
TABLE IV. Examination of end item for defects in general construction.
EXAMINATION
DEFECT
Assembly of sheets
Not evenly and uniformly stacked; sheet containing
manufacturer's sealing conditions not visible upon opening.
Adjacent sheets stick together to the extent that separation
causes tearing or injury to any surface.
Splice within sheet.
Assembly of roll
Not restrained to prevent unwinding.
Material not wound uniformly on roll causing soft or uneven
edges, or telescoping of roll.
Material not wound on a rigid core, core broken, collapsed,
crushed, mutilated.
Unwinding of roll (check
When unwound, material sticks together to the extent that
both sides)
unrolling causes tearing or injury to any surface.
Material wound unevenly causing wrinkles, sharp creases, or
folds within roll.
Roll not continuous; more than 3 splices (4 pieces) in roll or
more than 1 splice in any 45 or less consecutive yards.
Splice(s) not evenly made; does not cover entire width of
material; comes apart during unwinding of roll.
Manufacturer's instructions for sealing conditions of the
Sealing instructions
material not attached to core of roll.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business