MIL-PRF-22019E
TABLE III. Examination of end item for defects in appearance, construction, and workmanship.
EXAMINATION
DEFECT
Form
Not roll or flat cut, as specified.
Appearance
Surfaces not clean; presence of any foreign matter, dirt, sand,
grit, or oil spots. (Note: Defects do not apply to outer
convolution of roll.)
Workmanship
Blister, crack, cut, hole, tear, sharp crease, chafed spot, or scuff
mark. (Note: Defects do not apply to outer convolution of roll.)
Evidence of delamination or embrittlement.
Edges not clean cut; ragged, crushed, or uneven.
Loose surface deposits (type I only).
Voids in the cohesive sealant (type II only).
Construction
Not uniform; layer or section missing, selvage present.
Identification markings
Illegible, incorrect, incomplete, or omitted.
Not in a continuous row of constantly recurring symbols.
Not in machine direction.
Incorrect color.
Printing is not alternating or as specified in 3.6.
TABLE IV. Examination of end item for defects in general construction.
EXAMINATION
DEFECT
Rolls or package of
Loss of coating or impregnation causing bald spots.
sheets
Coating or impregnation completely missing.
Granular sandpaper surface.
Assembly of sheets
Not evenly and uniformly stacked; sheet containing
manufacturer's sealing conditions not visible upon opening.
Adjacent sheets stick together to the extent that separation
causes tearing or injury to any surface.
Splice within sheet.
Assembly of roll
Not restrained to prevent unwinding.
Material not wound uniformly on roll causing soft or uneven
edges, or telescoping of roll.
Material not wound on a rigid core, core broken, collapsed,
crushed, mutilated.
When unwound, material sticks together to the extent that
Unwinding of roll
unrolling causes tearing or injury to any surface.
(check both sides)
Material wound unevenly causing wrinkles, sharp creases, or
folds within roll.
Roll not wrapped with at least one thickness of MIL-PRF-131,
class 1 material.
Manufacturer's instructions for sealing conditions of the material
Sealing instructions
not securely attached to core of roll as specified in 3.5.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business