MIL-PRF-22019E
TABLE II. Conformance tests.
Characteristics
Paragraph
Reference
Seam strength - as received
4.6.2.2
Tearing strength
4.6.1
Vapor inhibitor ability
4.6.1
Contact corrosivity
4.6.1
Transparency - as received
4.6.1
4.3.1 Sampling for conformance inspection. Unless otherwise specified, sampling for
inspection shall be performed in accordance with the provisions set forth in ASQ-Z1.4.
4.3.2 Examination of the end item. For the purpose of determining the sample size in
accordance with ASQ-Z1.4, the lot size shall be expressed in units of rolls or packages of sheets,
as applicable, for examinations under 4.3.2.1 through 4.3.2.3.
4.3.2.1 Examination of the end item for defects in appearance, construction, and
workmanship. For examination of defects within rolls, the sample unit of the end item shall be
two yards, the full width of the roll. For examination of sheets, the sample unit shall be two
sheets randomly selected from a package. No more than five sample units, randomly selected,
shall be drawn from any one roll or package of sheets, as applicable. Both sides of the barrier
material shall be examined.
4.3.2.2 Examination of the end item for defects in general construction. The sample unit
for this examination shall be one roll or one package of sheets, as applicable.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business