MIL-PRF-3420H
ASTM-D130
-
Copper, Corrosiveness to, from Petroleum Products by the
Copper Strip Test (DoD adopted)
ASTM-D689
-
Paper, Internal Tearing Resistance of (DoD adopted)
ASTM-D774
-
Bursting Strength of Paper (DoD adopted)
ASTM-D5486
-
Standard Specification for Pressure-Sensitive Tape for
Packaging, Box Closure, and Sealing (DoD adopted)
(Copies of these documents are available from www.astm.org or ASTM International, 100
Barr Harbor Drive, West Conshohocken, PA 19428-2959.)
2.4 Order of precedence. In the event of a conflict between the text of this document and
the references cited herein, the text of this document takes precedence. Nothing in this
document, however, supersedes applicable laws and regulations unless a specific exemption has
been obtained.
3. REQUIREMENTS
3.1 Qualification. The treated carriers furnished under this specification shall be products
that are authorized by the qualifying activity for listing on the applicable qualified products list
before contract award (see 4.2 and 6.3).
3.2 Material. Treated carriers shall be made from such materials and by such processes as
to ensure compliance with all of the requirements of this specification. The treated carriers shall
have no adverse effect on the health of personnel (see 4.2.1 and 6.3.4).
3.3 Construction. Wrapping material covered by this specification shall consist of a neutral
pH carrier treated with a volatile corrosion inhibitor (VCI) in the form of a coating or an
impregnation.
3.4 Form of material. The treated carrier shall be furnished in rolls or flat cut sheets as
specified in the contract or delivery order (see 6.2).
3.4.1 Rolls. Unless otherwise specified (see 6.2), rolls shall be 36 inches wide with a
tolerance of plus 1/4 inch and minus 1/8 inch. The length of roll material shall be not less than
200 yards (see 4.3.2.3). Material shall be wound evenly on roll and shall be restrained to prevent
unwinding of the roll (see 4.3.2.2).
3.4.2 Utility rolls. Unless otherwise specified (see 6.2), utility rolls shall be 18 inches wide
with a tolerance of plus 1/4 inch and minus 1/8 inch. The length of roll material shall be 10 yards
long with a tolerance of plus 6 inches (see 4.3.2.3).
3.4.3 Sheets. Unless otherwise specified (see 6.2), flat cut sheets shall be 24 inches wide
and 36 inches long. The tolerance for the length and width shall be plus 1/4 inch and minus 1/8
inch (see 4.3.2.3). Sheets shall be evenly stacked (see 4.3.2.2).
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business